Datel MAY600 PON OTDR Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} Datel MAY600 PON OTDR. Datel MAY600 PON OTDR 19 pagina's.

3.5. Turn on/off Instrument

Press the button of the switch button, the ON led is on if the instrument starts normally, and the instrument enters the

main interface.

When the battery power is too low, warning information will appear, please charge the instrument in time.

3.6. Optical fiber connection

Attention:

The laser output port of the instrument or the tail end of the optical fiber connected to the port is prohibited to face the

eye in any case; otherwise the eyes will case the damage which can not be restored.

Please confirm whether the connector type matches, whether the end of optical fiber connector cleaned before connecting

the optical fiber. The w rong connector type or unclean end of the fiber will cause the test to fail, and may damage the

optical interface of the instrument. The correct method of cleaning the optical fiber interface is to clean the end face of the

optical fiber connector with anhydrous alcohol, and then connect with the instrument.

The dust cap of the instrument port should be covered so as to prevent dust or other contaminants from polluting the end

face of the optical fiber after finishing using.

3.7. Setting Test Conditions

3.7.1. Automatic test

1. Press settings button

2. Select test wavelength

3. Select measurement mode

4. Select automatic test

Dirección: Calle México 1554 Edif. Chuquiago MZ-2

Teléfono/Fax: (2)2-231-1125 / 211-4820

Cel.: 71521900 / 71535025

Pagina web: www.datelsrl.com