Austral Lock ELEGANCE PUSH2GO Geïllustreerde montage-instructies
Blader online of download pdf Geïllustreerde montage-instructies voor {categorie_naam} Austral Lock ELEGANCE PUSH2GO. Austral Lock ELEGANCE PUSH2GO 2 pagina's.
Pagina afdrukken
ELEGANCE
P U S H 2 G O
for hinged security doors
Austral
ock
1.
LOCKBODY INSTALLATION
● The Sticker on the rear of
the Lockbody is to assist
in easy installation. - Do
not remove.
● If the Sticker has been
broken or removed, en-
sure that the Rear Slide
is pushed completely
down before assembling
the Lockbody into the
door cutout.
● Insert the Lockbody into
the door cutout
● Secure the Lockbody
with the two #8x13mm
Lockbody screws.
2.
CYLINDER INSTALLATION
IMPORTANT : If installing PUSH2GO with a multipoint acces-
sory kit, be sure to follow the cylinder installation procedure
within the multipoint kit instructions.
● Depress the Auxiliary Bolt
to ensure the Main Bolt is
fully extended.
● Assemble the Cylinder
through the lock so the Cyl-
inder protrudes equally from
both sides.
NOTE : the Cylinder Cam
must rotate as shown below.
(cam turns towards front of
door)
● Insert the Key and turn to
locked position.
● Insert #10 x 38mm Cylinder
Screw & tighten.
NOTE : test, Main Bolt
should not depress.
● Turn Key to unlocked posi-
tion and remove Key.
Sticker
Rear Slide
Auxiliary
Cylinder
Cylinder
Cam
Cylinder
Cam operation
●
Lockbody screws.
3.
EXTERIOR FURNITURE
● Select the Exterior Handle
assembly.
● If the Handle does not point
towards the door hinges,
remove it from the Handle
Plate and exchange with
the other handle.
● Ensure the Locking Hub is
rotated so the pip is closest
to the door edge.
rotate Hub so that
the pip is closest
to door edge
●
Lockbody screws.
4.
INTERIOR FURNITURE
● Select the Interior Handle
assembly with Snib Lever
hole.
● Hold the Snib Lever hor-
izontally and insert it into
the snib lever hole, turn it
until vertical to secure it.
● While holding the Snib
Lever vertical, place the
Lever Assembly against
the door.
●
Lockbody screws.
5.
INSTALL THE FURNITURE
● Insert the Handle Rod
through the Lock Body.
● Locate the Exterior
Bolt
Handle assembly over
the Lock Body.
Main
● Engage Snib Lever into
Bolt
Locking Hub.
● Fit the two #8x32mm
Furniture screws.
Screw
PLEASE TURN OVER
Handle
Rod
oem1doc03_R2