Austral Lock HD16P plus Montage-instructies - Pagina 2
Blader online of download pdf Montage-instructies voor {categorie_naam} Austral Lock HD16P plus. Austral Lock HD16P plus 3 pagina's.
Pagina afdrukkenHD16 PLUS
Fitting instructions continued...
DOOR SECTION
Figure 5
COLLAR LUG
USING A SCREWDRIVER, SECURELY CLIP
THE COLLAR LUGS INTO THE DRIVE BOX
Figure 6 - Fitting Remote Strike Plates
SCREW HOLE
BROKEN EDGE
REMOTE
STRIKE PLATE
CHISEL TIMBER
15mm DEEP
RECESS HOLES
DOOR JAMB
Fitting the Levers and Face Plates
1
Fit and secure the face plates to the remote locks using the
#8x13 blunt point screws supplied.
2
Fit the HD8 levers & cylinder as per the supplied HD8
instructions.
3
Using the cylinder and the snib lever, test that the remote locks
unlock and lock smoothly and lively.
Fitting the HD8 Centre Lock Strike Plates
1
Fit the HD8 strike plate as per supplied HD8 instructions (STEP 7).
Fitting the HD16 Remote Lock Strike Plates (Figure 6)
1
Ensure the lock is unlocked and the remote beaks are retracted.
2
Pencil mark the door jamb at the same height as the remote beak
cutout (refer to indicator lines, figure 6).
3
Centre the strike plate square cutout over the pencil marks on
the door jamb. Ensure the strike plate is orientated as shown in
figure 6. The broken edge of the strike plate must be facing the
outside of the building.
4
Pencil mark through the screw holes, square cutout and the two
recess holes BENEATH the square cutout.
5
Pilot drill the screw holes if necessary.
6
Remove the timber 15mm deep with a chisel between the TOP of
the square cutout, and the two recess holes BENEATH the
square cutout.
7
Secure the strike plate to the door jamb with the two #8x25mm
screws supplied.
8
Repeat the process for the remaining remote strike plate.
9
Test the fit between the main beak / remote beaks and the strike
plates / door jamb to ensure there is adequate clearance around
all sides.
REMOTE BEAK
INDICATOR LINES
FACE PLATE