4RF Aprisa SR+ Handmatig - Pagina 12
Blader online of download pdf Handmatig voor {categorie_naam} 4RF Aprisa SR+. 4RF Aprisa SR+ 12 pagina's. Demo kit
Ook voor 4RF Aprisa SR+: Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's)
12 | Default Configurations
Layer 2 Filter
Layer 2 Filter
Layer 2 Filter Rules
Allow ARPS
Allow Unicasts from ANY source
Moxa RTU
The RTU has been preconfigured to the requirements of this demo kit. However, should the settings be
changed in any way, the parameters can be re-configured by following these steps:
The factory default IP address of the RTU (MOXA ilogik E2124) is 192.168.127.254
1. Open Web browser and enter: 192.168.127.254
2. Navigate to Network Settings > Ethernet Configuration
a. Set the IP address to: 172.17.200.220
b. Set the subnet mask to: 255.255.0.0
c. Set the gateway to: 0.0.0.0
3. Navigate to I/O Settings > D0 Channel Settings
a. Configure D0 channel 3 to Power Settings "ON"
Laptop
Network Connections
Local Area Connection
Properties
Internet Protocol TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Advanced TCP/IP Settings
WNS
Wireless Network Connection
enabled
Source
MAC Address
FF:FF:FF:FF:FF:FF
FF:FF:FF:FF:FF:FF
172.17.200.110
255.255.0.0
0.0.0.0
(none)
Disable NetBIOS over TCP/IP
Disable
Aprisa SR+ Demo Kit Guide 1.3.0
Destination
MAC Address
FF:FF:FF:FF:FF:FF
FE:FF:FF:FF:FF:FF
Terminal Emulator
COM Port Settings
BaudRate
38400
Data
8 bit
Parity
None
Stop
1 bit
Flow Control
None
Terminal Settings
ASCII Receiving
CR+LF
Character delay
0
Line delay
0
Protocol Type
ARP
ANY
(line feed after receiving a text file)