4RF Aprisa LTE Snelstarthandleiding - Pagina 6
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 4RF Aprisa LTE. 4RF Aprisa LTE 7 pagina's. Lte cellular router
Ook voor 4RF Aprisa LTE: Snelstarthandleiding (7 pagina's)
Pagina afdrukken
Page 6
5. Configure the Aprisa LTE
1.
Go to Supervisor > Services > Date & Time and set the time zone
offset, and format.
2.
Verify that the Aprisa LTE active software and LTE module are
correct for the provider.
Go to SuperVisor > Cellular > Summary to view the currently
supported bands.
Go to SuperVisor > Cellular > General and select the specific
band in use or leave the default 'Select All' option.
3.
Go to SuperVisor > Cellular > General to view the SIM status.
•
Set the SIM PIN.
Note: not all cellular operators use a pin to enable the SIM
card so the SIM pin may not be required.
•
Set the Preferred Provider to match that of the SIM card.
4.
Go to SuperVisor > Cellular > General (optional)
•
Set the Packet Data Network (PDN) Profile Name (if
required).
•
Set the active / backup Access Point Names (APNs) per your
installed SIM(s).
•
Set the SIM slot.
•
The Aprisa LTE features an auto APN feature, so only
change the Packet Data Network details if required.
Note that a corporate network requires both a private APN
name and the Mode set to Enable.
•
Tick Roam to switch from the home network (i.e. the SIM
network) to the roaming network when the Aprisa LTE is
outside the range of its home network and connects to
another available cellular network. When on the roaming
network, charges may be applied per customer contract.
5.
If the Wi-Fi network module is installed on your LTE, and you
want
to
enable
Interfaces/Networking > WiFi and click Edit.
•
Under the General Setup tab click Enable. If required, you
can change the Wi-Fi WLAN Operating Parameters (mode
and channel).
provide the widest Wi-Fi compatibility while 802.11n/ac
will provide the fastest Wi-Fi speeds.
•
On the same page, use the Interface Configuration tabs set
the Wi-Fi password ESSID and required security settings.
this
feature,
go
to
Note that the mode 802.11b/g/n will
SuperVisor
>