AUSTRALIAN MONITOR AMIS60 Installatie- en bedieningshandleiding - Pagina 7
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AUSTRALIAN MONITOR AMIS60. AUSTRALIAN MONITOR AMIS60 12 pagina's. Amis installation series 60w / 120w mixer amplifier
Ook voor AUSTRALIAN MONITOR AMIS60: Bedieningshandleiding (10 pagina's), Gegevensblad (2 pagina's), Brochure (2 pagina's)
Pagina afdrukken
Levels
Volume controls should aimed to be set at nominal, which is at the half or 12o'clock position. Any unused channels should be set to minimum.
When establishing a mix, remember: Less is more.
TR O U B L E SH O O T I N G GUI DE
TROUBLE
Power LED not on
Distorted sound
No sound but amp is on
No sound from channels 3-6
Condenser microphone does not work
PRIORITY
Channel 1 and 2 are set up to mute channels 3 to 6. This
will only occur when signal appears on channel 1 or 2
irrespective of the channel volume control.
Priority can be disabled. (See below).
The release time is approx. 1 sec and is NOT adjustable.
The mute depth is greater than 60dB and is not adjust-
able.
A M I S S E R I E S I N S TA L L AT I O N & O P E R AT I O N M A N U A L
AMIS SERIES 60/120 manual.indd
7
S E T U P & T R O U B L E S H O O T I N G
LIKELY CAUSE
Power not reaching amplifier
Output is short circuit
Input is overloaded
Output is being over driven
Bass control is turned up
DC fuse(s) blown
Volume controls down
Amplifier has overheated
Priority function is being used
Phantom power not switched on
REMEDY
Check mains connection
Check mains fuse
Check power switch is on
Check speaker loads for shorts
Reduce input level at source
Reduce volume levels on front panel
Reduce Bass control level
Refer product to local Australian Monitor dealer
Check volume controls
Make sure the amplifier is
well ventilated.
Remove signal (disconnect input) from
channel 1 OR
Disable priority function (see Internal
Adjustments)
Turn on phantom power switch on back panel.
PA G E 7
2/7/07
12:42:34 PM