4tronix Pi2Go Lite Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} 4tronix Pi2Go Lite. 4tronix Pi2Go Lite 7 pagina's.

Step 2 - Fit the Mounting Pillars for Raspberry Pi

For the older Raspberry Pi models with a 26-pin GPIO connector, you will need to fit 2

pillars. For the A+, B+ and RPi 2B you should fit 4 pillars

Fitting the pillars is a 2 step process: 1) fit the small 5mm pillars, 2) screw in the 16mm

pillars.

The photo above shows the 5mm pillars in the mounting positions for A+, B+ and RPi 2B

models

Use the very small 4mm screws to attach all the pillars. Note that the holes under the motors

have been countersunk to allow the motors to sit flat onto the PCBA

The photo above shows the 16mm pillars added for the correct height (A+, B+, RPi 2B)