Bender ATICS-2-ISO Series Snelstarthandleiding - Pagina 6

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Bender ATICS-2-ISO Series. Bender ATICS-2-ISO Series 8 pagina's. Automatic transfer switching devices with monitoring functions for unearthed safety power supplies - software version: d333 v1.3x, d334, v1.3x, d335 v1.0x, d308 v1.2x
Ook voor Bender ATICS-2-ISO Series: Snelstarthandleiding (16 pagina's)

Pagina afdrukken
ATICS-2...-ISO Quick start

6. Enabling automatic mode

7. Display in error-free operation

There is no alarm message. Standard display:
1
2
228V
1
0
50.0Hz
160kΩ
14:11
12.10.2010
6
5
Alternate displays in the bottom line of the display
The device displays alarm messages in the bottom line of the dis-
play. Also shown there are: switching back interlocking function,
manual mode, countdown timer for return transfer time
8. Display during fault condition
There is an alarm message:
• The yellow LED "Alarm" lights up.
• Information about the message appears on the display in the bottom line.
Example: Line 2 has no voltage
228V
1
0
2
50.0Hz
160kΩ
14:11
Undervoltage
ALARM
Undervoltage
0V
Addr.:3 Chan.:2
9. Menu mode: Operation and configuration
►
Press the "MENU" button to open the main menu.
– Use the arrow buttons to go up resp. down one menu level.
– Press the "↵ " button to confirm the selected menu item.
– Press the "ESC" button to leave the menu.
10. Menu overview
Main menu
Meaning
Exit
Exit menu mode
2
3
231V
2
50.0Hz
35 %
4
0.00V
0.00Hz
35 %
xx/yy
►
In order to enable automatic mode, close the transparent
cover of the automatic transfer switching device and seal it, if
necessary.
Pos. Meaning
1
Line 1: Measured values of mains voltage and frequency
2
Switch position of the automatic transfer switching device
3
Line 2: Measured values of mains voltage and frequency
4
Display of the load in the IT system in %. The maximum load
current is adjustable.
5
Date and time
6
Measured value of insulation resistance
The device shows the alarm status for each measured value:
No alarm
Alarm
►
Press the "↵" button to display the current alarm.
The alarm message consists of:
– Line 1: Alarm
xx = Serial number of the displayed alarm
yy = Number of pending messages
– Use the arrow buttons to select the previous or next mes-
sage.
– Line 2: Alarm status and alarm text
– Line 3: Measured value
– Line 4: Address and channel of device triggering message.
►
If no button is pressed for a few seconds, the standard dis-
play reappears.
►
Press the Enter button again, then the main menu will
appear.
Submenu:
Meaning/Setting
ATICS-2-ISO_D00046_02_Q_XXEN/09.2016