BENDIX TR-2 Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} BENDIX TR-2. BENDIX TR-2 4 pagina's. Inversion valves
Ook voor BENDIX TR-2: Servicegegevens (4 pagina's)

Pagina afdrukken

FIGURE 4 - TR-4

™

INVERSION VALVE

Slowly decrease pressure in the control cavity and note at

what pressure delivery is made and compare with vehicle

manual.

NOTE: In the TR-3

™

valve shown in Figure 3 and the TR-4

valve in Figure 4, control pressure is reduced by

decreasing supply air pressure because of the

internal passage connecting supply and control.

™

If the TR-2

, TR-3

or TR-4

as described or leakage is excessive, it is recommended

that it be replaced with a new valve or remanufactured unit,

or repaired with genuine Bendix parts available at Bendix

outlets.

WARNING! PLEASE READ AND FOLLOW

THESE

INSTRUCTIONS

PERSONAL INJURY OR DEATH:

When working on or around a vehicle, the following

general precautions should be observed at all times.

1. Park the vehicle on a level surface, apply the

parking brakes, and always block the wheels.

Always wear safety glasses.

2. Stop the engine and remove ignition key when

working under or around the vehicle. When

working in the engine compartment, the engine

should be shut off and the ignition key should be

removed. Where circumstances require that the

engine be in operation, EXTREME CAUTION should

be used to prevent personal injury resulting from

contact with moving, rotating, leaking, heated or

electrically charged components.

3. Do not attempt to install, remove, disassemble or

assemble a component until you have read and

™

inversion valve does not function

AVOID

PLUNGER

PLUNGER SPRING

SHIM

PISTON SPRING

PISTON

O-RING

PLUGGED

INLET/EXHAUST

VALVE

VALVE STOP

O-RING

1/4" P.T. SUPPLY

thoroughly understand the recommended

procedures. Use only the proper tools and observe

all precautions pertaining to use of those tools.

4. If the work is being performed on the vehicle's air

™

brake system, or any auxiliary pressurized air

systems, make certain to drain the air pressure from

all reservoirs before beginning ANY work on the

vehicle. If the vehicle is equipped with an AD-IS

air dryer system or a dryer reservoir module, be

sure to drain the purge reservoir.

5. Following

recommended procedures, deactivate the electrical

system in a manner that safely removes all electrical

power from the vehicle.

6. Never exceed manufacturer's recommended

pressures.

7. Never connect or disconnect a hose or line

containing pressure; it may whip. Never remove a

component or plug unless you are certain all

system pressure has been depleted.

8. Use only genuine Bendix

components and kits. Replacement hardware,

tubing, hose, fittings, etc. must be of equivalent

size, type and strength as original equipment and

be designed specifically for such applications and

systems.

9. Components with stripped threads or damaged

parts should be replaced rather than repaired. Do

not attempt repairs requiring machining or welding

unless specifically stated and approved by the

vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make

certain all components and systems are restored

to their proper operating condition.

LEVER

COVER

LOCK NUT

COVER NUT

O-RING

1/4" P.T.

DELIVERY

VALVE

SPRING

CAP

the

vehicle

manufacturer's

replacement parts,

™