BENDIX ULTIMATE TOW Handleiding voor installatie en gebruik - Pagina 3

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} BENDIX ULTIMATE TOW. BENDIX ULTIMATE TOW 6 pagina's.

Pagina afdrukken
Specifications
Minimum Input Voltage
Nominal Input Voltage
Maximum Input Voltage
Suitable For 12V Trailer Brakes
No Current Load
Maximum Load
Weight
Dimensions
Note: Ultimate Tow is load activated and cannot be tested without load. At no load, the output reading of high voltage will register.
The output voltage is PULSED, so it cannot be measured with a voltmeter or test light.

INSTALLATION:

1.
Disconnect the vehicle's NEGATIVE battery terminal.
2.
Determine a suitable mounting location inside the cabin.
3.
Hold the brake controller in the selected position and
mark the hole location through the holes in the flanges
of the unit.
4.
Using a suitable drill bit, drill holes in the marked locations.
5.
Secure the brake controller in position with self-tapping
screws. Take care to not strip the holes by over-tightening
the screws or use the nylon fabric fastening hook and loop
straps, or double-sided adhesive pad to secure.

WIRING DIAGRAM

Model
Fuse
ULTTOW12V
15A
To Remote Control
Note: If you cannot attach to the vehicle brake switch. Follow the alternative wiring diagrams.
To Positive Voltage Feed
(ie. Battery Positive)
Fuse must be fitted
(Supplied)
BLACK
FUSE
WHITE
BLUE
To trailer brake wire /
Pin 5 on Trailer Plug
Earth
as described in
AS 4177.5-2004
9 VDC
12 VDC
15 VDC
Yes
30 mA
2 Axle /14A avg
200g
L x W x H: 30mm x 57mm x 90mm
6.
Drill a hole for the 8.5mm remote control shaft in a
suitably sized mounting panel in the dash with a wall
thickness of less than 4mm.
7.
Affix decal, washer and retaining nut over shaft and
tighten. Turn shaft fully counter-clockwise and affix the dial
on the shaft with firm, even pressure with the indicator
facing the minimum position.
8.
Plug the remote control lead into the brake controller.
9.
Connect brake wiring as per wiring instructions and follow
Set-up and Operation procedures.
10.
Reconnect the NEGATIVE battery terminal.
RED
To Vehicle Brake Switch (Cold Side)
or source that is pure DC when
vehicle brake lights are on.
Note: Only Activated by Positive feed.