DAW Industries EZ-Access DAWSKIN Snelstarthandleiding - Pagina 6
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} DAW Industries EZ-Access DAWSKIN. DAW Industries EZ-Access DAWSKIN 8 pagina's.
Pagina afdrukken
STEP
4
WARM, THEN DON THE EZ-ACCESS DAWSKIN
Warming the DAWSKIN makes it much easier
1. Warm Using Oven Or Hair Dryer (DO NOT OVERHEAT)
Warming in Oven (Recommended)
Heat oven to 120-Degrees. Place DAWSKIN on edge of oven with door open.
Warm for 90 seconds, then flip. Warm other side for 90 seconds.
Warming with Hair Dryer
Thoroughly warm the DAWSKIN with a hair dryer to 120º F (5º C).
Use of a heat gun will damage the DAWSKIN (cracking will occur,
though it will not be immediately apparent).
2. Don the EZ-Access DAWSKIN as you would a stocking. While still warm,
carefully stretch DAWSKIN over the heel. Then pull fully up the leg all the way above
the socket brim.
NOTE:
For continuous AK covers, check proper
tension by bending knee and straightening, wrinkles
should disappear in seconds
3. Apply 3/4in (2cm) masking tape on EZ-Wrap all the way
around at the top edge of the DAWSKIN. (Img. A)
4. Fold over top 1in (2.5cm) of EZ-Access DAWSKIN. (Img. B)
5. Apply S-Glue "Release Formula" on both the exposed
EZ-wrap below the tape and the folded over portion
of the DAWSKIN. (Img. B)
6. Let glued on surfaces reach a stage of dry-tacky.
(approximately 2 minutes).
7. Unfold the top of the DAWSKIN back over The
EZ-Wrap and apply slight pressure.
8. Remove masking tape.
9. Prosthesis can be dispensed immediately.
to pull over the heel and onto the leg.
(NOT A HEAT GUN)
Pg. 5
Img. A
Masking Tape
EZ-Access
DAWSKIN
Img. B
Masking Tape
S-Glue
Release
Formula
EZ-Access
DAWSKIN