Gage Bilt GB510LGP Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} Gage Bilt GB510LGP. Gage Bilt GB510LGP 7 pagina's. Hydraulic installation tool
Pagina afdrukkenPLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS TOOL. COMPLETE
WITH WARNINGS AND CAUTIONS TO PREVENT SEVERE PERSONAL INJURY OR
GAGE BILT TOOLS ARE APPROVED TO INSTALL HUCK®, AVDEL®, CHERRY®, POP®
AND OTHER FASTENERS WHEN USED BY PERSONS WITH SPECIFIC TRAINING OF
BLIND RIVET AND LOCKBOLT INSTALLATION EQUIPMENT.
WARNING
Do not pull fastener unless it is placed in
an assembly, pin will eject forcibly when
pintail breaks off. Severe personal injury
may result.
WARNING
When operating installation equipment
always wear approved eye protection. Do
not look in front of nose assembly or rear
of tool when installing fastener.
WARNING
Installation of fasteners may exceed
acceptable noise levels. Use approved
hearing protection.
CAUTION
Keep Nose Assemblies clean and free of
chips and debris.
WARNING
Powerunit pressures are set at the
factory. DO NOT change pressures
without the proper equipment.
WARNING
Read powerunit manual for proper tool
installation instructions.
NOTE:
DAMAGE THE TOOL.
CAUTION:
Always disconnect tool from powerunit
before performing any maintenance to
any tool or nose assembly. Insure that all
connections are proper and there are no
visible leaks from tool or hoses before
Insure that nose assembly and tip are
properly matched for the fastener being
Be sure there is adequate clearance for
proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from
fasteners and installed materials. Severe
Hydraulic power units that deliver high
pressure for the "PULL" and "RETURN"
and are not equipped with relief valves
are specifically not recommended and
2
WARNING
connecting to power.
CAUTION
installed.
WARNING
tool and operator's hands before
personal injury may result.
WARNING
may be dangerous.