Gage Bilt GB2581-750 Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} Gage Bilt GB2581-750. Gage Bilt GB2581-750 10 pagina's.
Pagina afdrukken
PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS TOOL.
WARNING
Do not pull fastener unless it is placed in an
assembly with collar, pin will eject forcibly when
pintail breaks off. Severe personal injury may result.
WARNING
When operating, repairing or overhauling tool, wear
approved eye protection. Do not look in front of
nose assembly or rear of tool when installing
WARNING
Do not operate if deflector, bottle, catcher bag or
vacuum tube is removed or damaged, broken
pintails may eject forcibly from rear of tool. Severe
personal injury may result.
Keep Nose Assemblies clean and free of chips and
Do not use beyond the design intent.
WARNING
Tool must be maintained in a safe working
condition at all times and examined on a regular
daily basis for damage or wear. Any repair should
be done by qualified personnel trained on Gage Bilt
procedures.
WARNING
Where prolonged use is foreseen, it is
recommended a tool balancer be used. Check
suspension device to ensure that it is secure.
WARNING
Do no use tool in explosive atmosphere.
It is recommended operator wear a suitable glove
during operation where prolonged use is expected.
SAFETY WARNINGS
REVIEW ALL WARNINGS AND CAUTIONS TO PREVENT
SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.
fastener.
CAUTION
debris.
CAUTION
WARNING
Shock:
NOTE:
Always disconnect tool from power before
performing any maintenance to any tool or nose
assembly. Ensure that all connections are proper
and there are no visible leaks from tool or hoses
before connecting to power.
Ensure that nose assembly and tip are properly
matched for the fastener being installed.
Be sure there is adequate clearance for tool and
operator's hands before proceeding. Keep fingers
clear of any moving parts. Keep fingers clear from
fasteners and installed materials. Severe personal
It is required to use hearing protection. A test was
carried out in a simulated work environment where
the background level was 73.2 DBA. In this
condition the max level was 81.5 DBA. Therefore, it
is required where prolonged use, hearing
Risk of crushing exists if nose assembly is not
It is recommended tool be operated 50 out of every
60 minutes, where prolonged use is expected.
Tool is not to be used as a hammer.
Hydraulic pressure not to exceed 7,400 PSI 510.2 bar
pull 3,200 220.6 bar reload
3
WARNING
CAUTION
WARNING
injury may result.
WARNING
protection be used.
WARNING
attached.
WARNING
CAUTION
CAUTION
10/13