Gage Bilt GB715 Originele handleiding - Pagina 14

Blader online of download pdf Originele handleiding voor {categorie_naam} Gage Bilt GB715. Gage Bilt GB715 20 pagina's.
Ook voor Gage Bilt GB715: Installatiehandleiding (17 pagina's)

Pagina afdrukken
Gage Bilt GB715 Originele handleiding
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly-air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly-air (704130). Snug tighten only.
REMOVING ACTUATOR ASSEMBLY-AIR (704130)
1.
Remove actuator lever assembly (704343) and pin-slotted (400608) from handle assembly (704132).
2.
Insert a 5/8" open end wrench / adjustable wrench around actuator assembly-air (704130).
3.
Loosen the actuator assembly-air (704130).
4.
Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from the
handle assembly (704132).
INSTALLING ACTUATOR ASSEMBLY-AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.
2.
Thread the actuator assembly-air (704130) all the way into handle assembly (704132) with fingers.
3.
Insert and turn 5/8" open end wrench / adjustable wrench and snug tight approximately 1/4-1/2 turn.
4.
Reattach actuator lever assembly (704343) and pin-slotted (400608) to handle assembly (704132).
GB752 S/N: 3210 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
ACTUATOR ASSEMBLY-AIR
14
REV. 5/22