Great American KPAW61 Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Great American KPAW61. Great American KPAW61 2 pagina's. Pet waste station

1. Pole Installation

18"

17"

12"

24"

18"

Need Help? Give us a call!

Using a post hole driver (not included), drive the sign post (C) approximately 15-18" into

the ground. Make sure that the "hollow" or "recessed" side of the post is facing where

you want the front of the unit to face. We recommend that the pole is no less than 15"

underground to support the weight of the waste receptacle (D) properly. Use a level (not

included) to ensure the pole is standing upright and will properly support the unit. Adjust

if necessary.

2. Station Assembly

1. Using the first hardware set (E), secure the sign (A) to the top of the steel post (C) with

a bolt and washer at the top of the sign and another at the bottom. The washers should

be next to the printed side (front) of the sign and the nuts are secured on the outside/

back of the post. To ensure the best outcome, make sure the sign is flush with the top of

the pole.

2. Using the second hardware set (E), attach the dispenser box (B) directly under the

sign leaving about 1" in-between. Open the box, align the holes to the steel post and

attach with the two bolts. The washers should be used on the inside of the box with the

nuts secured to the outside/back of the post.

3. Using the final hardware set (E), secure the waste receptacle (D) to the steel post

at the top and the bottom with the washers facing the inside of the waste can and the

nuts on the outside/back of the post. Make sure that the receptacle is approximately

12 inches below the dispenser box to allow for the lid to be open and trash to be easily

removed. This should leave your receptacle approximately 6 inches off the ground which

will help prevent any damage to the station from bad weather conditions.

3. Station Preparation

Insert one waste liner (G) into the waste receptacle and fold over the rim. Open the

dispenser box and insert up to 10 header cards of bags (F) onto the prongs inside the

dispenser. Close the station, pull the top bag through the hole and you're all set!

Note: This dispenser fits all types of bags. If you are using boxed bags (PAWBAG3), you will need

to slip a converter (Great American Item PAW22) onto the prongs inside the dispenser and insert

the boxes into the converter.

Please contact us immediately if you have any missing or damaged items

or need any additional assistance. Thank you.

Great American

•

1-800-231-0329

•