Dawn 1203 Montage- en bedieningshandleiding - Pagina 5

Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} Dawn 1203. Dawn 1203 7 pagina's.

JOHN DEERE, KINZE & WHITE

For this assembly you will need;

•

One open-end 15/16" wrench

•

Dawn 1 3/8" hub wrench

•

3/4" socket wrench or impact gun

NOTE This installation is intended as a starting point for most

growers with seed depths ~2-2.5". To change spacing, add or

remove supplied washers as necessary.

Install Hub

Insert hub shaft through 1 supplied washer, tailpiece, lock

washer, and thread into nut. Tighten by placing 15/16" wrench

onto nut and turning hub shaft using the supplied Dawn 1 3/8"

wrench. To tighten, turn Dawn wrench TOWARDS planter

unit. To loosen hub, turn Dawn wrench AWAY from planter

unit. Remember that each hub is handed.

Install Curvetine

Place triangular hub spacer between Curvetine and hub,

thread on 5/8" flange lock nuts. Remember to install wheel

according to the rotational arrow stamped on the outside

of the wheel.

Install Rubber Wheel

Place rubber wheel onto hub, secure 1/2-13" flange lock nuts

with 3/4" socket or impact gun.

INSTALLATION

To install hub, turn

wrench TOWARDS

planter unit.

www.dawnequipment.com

Toll Free: 800.554.0007

Fax:815.899.3663