Frigidaire 79045074401 Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Frigidaire 79045074401. Frigidaire 79045074401 13 pagina's. 30" electric drop-in range

Pagina afdrukken
l Electrical
Requirements
This appliance must be supplied with the proper voltage
and frequency, and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse, having amperage as noted on the rating plate (the
rating plate is located on the oven frame).
If local codes permit, you can use a 3-wire single phase
120/208 or 120/240 Volt, 60Hz AC only electrical
system. If you connect to aluminum wiring, properly
installed connectors approved for use with aluminum
wiring must be use.
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the National Electrical Code ANSI/NFPA No. 70-
latest edition, and local codes and ordinances.
Electrical
Shock Hazard
• Electrical
ground
is required
on this appliance.
• Do not connect
to the electrical
supply
until
appliance
is permanently
grounded.
• Disconnect
power
to the junction
box before
making the electrical
connection.
• This
appliance
must
be
connected
to
a
grounded,
metallic,
permanent
wiring
system,
or a grounding
connector
should
be connected
to the grounding
terminal
or wire
lead on the
appliance.
• Do not use a gas supply line for grounding
the
appliance.
Failure to do any of the above could result in a
fire, personal injury or electrical
shock.
This appliance is manufactured with a neutral (white)
power supply wire and a cabinet-connected
green (or
bare copper) grounding wire.
Connect the appliance cable to the junction box through
the U.L.-listed conduit connector. Complete electrical
connection according to local codes and ordinances. (For
preferred junction box location, see Figure 1.)
Where local codes permit connecting the cabinet-
grounding
conductor
to the neutral
(white)
junction
box wire (see Figure 2)
(The 3-conductor cord or cable must be replaced with a
4-conductor cord or cable where grounding through the
neutral conductor is prohibited in new installations,
mobile homes, recreational vehicles or in other areas
where local codes do not permit neutral grounding)
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
connect the appliance and the residence cable wires
as shown in figure 2.
White Wire
(Neutral)
Cable from
Residence
Wires -
Box
White
Wire
(Neutral)
Green _
U.L.-listed
(or Bare Copper)
Conduit
Wire
Cable from
Connector
Range
(or CSA listed)
Figure
2
3-Wire
(Grounded
Neutral)
Electrical
System
(Example:
Junction
Box)