Gaggenau 400 Series Installatie-instructies
Blader online of download pdf Installatie-instructies voor {categorie_naam} Gaggenau 400 Series. Gaggenau 400 Series 4 pagina's. Vario electric grill 38 cm
Ook voor Gaggenau 400 Series: Gebruiks- en onderhoudshandleiding (18 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's)
Pagina afdrukken
VR414115
Included accessories
1 x cast pan
half size
2 x cast iron grill
1 x lava stones
1 x cleaning brush
Optional accessories
LV030000:
Lava stones
Installation accessories
CKR420000:
2 knobs, grill, black
CKR420010:
2 knobs, grill, stainless steel
VA420004:
Connecting strip Serie 400, flush, short
VA420010:
Connecting strip Serie 400, top, short
VA440010:
Appliance cover Vario 400 series
Vario electric grill 400 series
38 cm
VR414115
Two zones can be operated together or
separately
Cast pan, half size, for simultaneous frying and
grilling on two separate surfaces
Open cast grill, lava stones
Precision crafted 3 mm stainless steel
For surface mounting with a visible edge or for
flush mounting
Can be combined perfectly with other Vario
appliances of the 400 series
Handling
Control knobs with illuminated ring, cooking
zone and output level markings.
Electronic control in 12 output levels.
Features
Cooktop, lava stone trough and grease
collecting insert from stainless steel.
Two zones, each 1500 W, can be operated
together as a complete surface or each half
separately.
Two-part cast grill.
Safety
Safety shut-off.
Pre-heat and residual heat indicator.
Planning notes
Depending on the type of installation
(surface-mounted or flush-mounted, with or
without an appliance cover), the specific
location of the cut-out and the knob positions
may vary.
If installing with the appliance cover VA 440 take
into account the additional space required for
the depth.
If combining several Vario appliances of the 400
series, a connection strip VA 420 must be
placed between the appliances. Depending on
the type of installation, the corresponding
connection strip must be provided.
The bearing capacity and stability, in the case of
thinner worktops in particular, must be
supported using suitable substructures. Take
into account the appliance weight and additional
loads.
Additional instructions for flush mounting:
Installation is possible in worktops made of
stone, synthetics or solid wood. Heat resistance
and watertight sealing of the cut edges must be
observed. Concerning other materials please
consult the worktop manufacturer.
The groove must be continuous and even, so
that uniform placing of the appliance on the
gasket is ensured. Do not use discontinuous
lining.
The joint width may vary due to size tolerances
of the combinations and of the worktop cut-out.
If installing several appliances in individual
cut-outs allow for a division bar of minimum 50
mm between the individual cut-outs.
A minimum lateral clearance of at least 100 mm
from adjacent heat-sensitive furniture or from the
wall must be observed.
Appliance can be snapped into the worktop
from above.
Appliance weight: approx. 25 kg.
Connection
Total connected load 3.0 KW.
Connecting cable 1.5 m without plug.
2024-01-16
1 /