Gaggenau Teppan Yaki VP 421-610 Gebruiksaanwijzing en montagehandleiding - Pagina 15

Blader online of download pdf Gebruiksaanwijzing en montagehandleiding voor {categorie_naam} Gaggenau Teppan Yaki VP 421-610. Gaggenau Teppan Yaki VP 421-610 20 pagina's.

Pagina afdrukken

6. Installation

Technical data

Total connected load: 1 500 W

AC 208/220-240 V / 60 Hz

Important notes on installation

This appliance can be combined with all Gaggenau

Vario 400 Series appliances.

This appliance may be installed in kitchen

combinations made of wood or similar combustible

materials without taking additional safety measures.

The built-in furniture and worktop where the

appliance is installed must be heat resistant up to

temperatures of 200° F/90° C.

The appliance must only be connected by an

authorised specialist, paying attention to the

relevant regulations of the power supply companies

and the regional construction regulations.

When connecting electrical appliances in the

proximity of cooking surfaces, make sure that

connecting cables do not come into contact with hot

cooking surfaces.

The installation technician is responsible for the

correct functioning of the appliance at the place of

installation. He must instruct the user on how to

disconnect the appliance from electricity in an

emergency.

After unpacking, check the appliance for any

transportation damage and report this immediately

to the transportation company.

Protection against accidental contact from below

must be provided by an intermediate shelf that

can only be removed with a tool. The distance

from the top of the work surface to the top of the

intermediate shelf must be at least 150 mm (6´ ´ ).

There must be a gap of at least 40 mm (1

side between the appliance and any walls or

furnishings.

If all poles of the appliances cannot be isolated

from the mains by removing an accessible plug, an

isolating device with a contact gap of at least 3 mm

must be installed (e.g. domestic fuse).

No warranty claims can be lodged for any

damage resulting from failure to observe these

instructions. Pay attention to the "Important

notes" on page 3 and 4.

Subject to technical change without notice.

Electrical connection

Only a qualified electrician should install this

appliance.

This appliance must be hardwired.

The mains connecting cable must at least

correspond to the type SJTO 3x16 AWG 105°C.

The mains connecting cable must only be

purchased through and connected by an

authorised specialist. The appliance must be

properly grounded. Pay attention to the

information on the rating plate.

´ ´ ) at the