Hi-Tech Diamond Slant Cabber Glass/Crystal Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Hi-Tech Diamond Slant Cabber Glass/Crystal. Hi-Tech Diamond Slant Cabber Glass/Crystal 16 pagina's.

Pagina afdrukken

TROUBLESHOOTING

My machine is vibrating...

The motor that is installed in the Slant Cabber

is variable speed, meaning you can adjust the

speed in-between the range of 800 rpm - 3,400

rpm. When the Slant Cabber runs at lower

speeds, you may experience a vibration. We

recommend running the Slant Cabber at higher

speeds to prevent this vibration. If you are still

experiencing a vibration after running the Slant

Cabber at high rpms, check to see if your discs

are properly centered. If the diamond lap disc,

diamond smoothing discs or polishing pads are

not accurately centered with the 1/2" arbor hole

in the backing plate, this will cause a vibration.

Remember to always use your machine on a flat,

sturdy workbench or surface.

Water isn't coming out of my water

tube.

This means an air bubble formed in the inner

tubing, causing a blockage in the water system.

Try one of two things:

1) Move the water tube clockwise in large circles.

2) Blow air through the top water reservoir fitting

using compressed air or a straw.

What should I do if the drain tube

keeps clogging with sediment?

If the drain tube keeps clogging with leftover rock

sediment, simply flush out the sediment with lots

of clean water until the sediment gets flushed

down the drain tube. If a large piece of sediment

is clogged and stuck in the drain tube, use an air

spray gun to blow it out.

My Slant Cabber makes a high speed,

"whirring" sound. Is this normal?

Yes, this is a normal sound the Slant Cabber

makes. The "whirring" sound is produced by a

thin, white disc (also known as a slinger) that is

installed under the arbor and around the motor

shaft. This disc prevents water from getting into

your motor.

My motor is beginning to rust, why is

this?

The only possible way the motor can rust is

if there is water getting into the motor. Water

should never get into the motor with the correct

water set up so if you are seeing rust, make sure

your water set up doesn't allow water to drip into

the motor.

I can't remove the arbor from the

motor shaft.

If you can't remove the arbor from the motor

shaft using the Allen wrench, it is most likely

because the arbor and motor shaft seized

together. This is a result from not oiling the inside

of the arbor according to the oiling instructions

on page 10. If it impossible to remove, please

contact Hi-Tech Diamond at 1 (630) 596-9909 and

one of our specialized technicians will help you

over the phone for correct removal.