Aircraft SG4001 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aircraft SG4001. Aircraft SG4001 6 pagina's.

Pagina afdrukken

6. TROUBLE SHOOTING

WARNING: Disconnect tool from air supply before performing any service procedure.
SPRAY PATTERN
1. Fluttering
2. Crescent
3. Inclined
4. Split
5. Heavy Center
6. Spit
PROBLEM
1. Air leaks
(from tip of air cap)
2. Paint leaks
3. Paint does not flow
Warning: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in serious injury
PROBLEMS
1. Air enters between fluid nozzle
and tapered seat of gun body.
2. Air is suctioned from fluid needle
packing
1. Paint buildup on air cap partially
clogs horn holes. Air pressure
from both horns differs.
1. Paint buildup on air cap partially
clogs horn hole or air cap center
hole, or causes damage.
2. Loose fluid nozzle.
1. Paint viscosity too low.
2. Fluid output too high.
1. Paint viscosity too high.
2. Fluid output too low.
1. Fluid nozzle and fluid needle set
are not seated properly.
2. The first-stage travel of trigger
(when only air discharges)
decreases.
3. Paint buildup inside air cap set.
CAUSE
1. Dirt or damage on seat.
2. Wear on air valve spring.
3. Damage or deteriorated o-ring
2. Dirt, damage, wear on the seat
3. Loose fluid needle adj. knob.
4. Wear on needle spring.
5. Insufficient tightening
6. Needle does not return due to
packing set too tight.
7. Needle does not return due to
paint buildup on fluid needle
1. Insufficient opening
2. Gun clogged
SOLUTIONS
1. Remove fluid nozzle to clean seat. If
it is damaged, replace the nozzle
2. Tighten fluid needle packing
1. Remove obstructions from born
holes. But do not use metal objects
to clean horn holes.
1. Remove obstructions. Replace if
damaged.
2. Remove fluid nozzle and clean seated
section.
1. Add paint to increase viscosity.
2. Adjust fluid adj. knob or pattern adj.
knob.
1. Reduce viscosity.
2. Increase fluid output.
1. Clean or replace fluid nozzle and fluid
needle set.
2. Replace fluid nozzle and fluid needle
set.
3. Clean air cap set.
SOLUTIONS
1. Clean the parts.
2. Replace the parts.
1. Clean the parts.
2. Replace the parts.
3. Adjust / retighten the parts.
1. Adjust the components after
reassembling.
2. Unclog the gun.
5