ADEMCO Accord Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ADEMCO Accord. ADEMCO Accord 10 pagina's.

NIGHT SET [3]

To Night Set the alarm system enter your

User Code then press the 3 (Night Set) key.

This sets a sub-part of the system and leaves

the rest unset, this would allow you to set

downstairs areas while leaving the upstairs

areas unset for instance – the installation

engineer will advise you on how your system

has been programmed for Night Set, also see

System Settings on Page 7. To cancel the

setting press the √ √ (Escape) key.

The setting routine is as described in Full Set

[1].

Easy Set – if programmed, allows you may

start the system Night setting by pressing the

# key then the 3 (Night Set) key.

To Unset the system go to the keypad via the

agreed entry route and enter your User Code.

UNSETTING AFTER OR DURING

AN ALARM

To stop an alarm that is in progress enter your

User Code. The zone that caused the alarm is

indicated on the Zone LEDs on the keypad. To

reset the system

TESTING THE ALARM

SYSTEM

[5]

To Test the system enter your User Code

then press the 5 (Test) key. The external

bell/sounder rings for five seconds and the

strobe flashes and all the zone LEDs on the

keypad light for five seconds.