Dynabrade Mini-Raptor Vac 61100 Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynabrade Mini-Raptor Vac 61100. Dynabrade Mini-Raptor Vac 61100 14 pagina's. Wet/dry vac commercial use 16 u.s. gallon 60.5 liter
Pagina afdrukkenby rinsing outside surface of filter with running water.
Avoid dampening inside of filter. Completely air dry filter
after washing. FIGURE 25.
32. Important: DO NOT BRUSH. DO NOT clean filter
media with abrasive materials. DO NOT scrub to clean
between pleats. This will permanently damage the
filter's ability to stop dust and will void warranty.
33. Check the filter for tears or small holes. If none are
found, reinstall the filter. To prevent damage to your
vacuum, do not use a filter with a hole or a tear.
WARNING!
KEEP FILTERS CLEAN. EFFICIENCY OF THE VACUUM
IS LARGELY DEPENDENT ON THE FILTER. A CLOGGED
FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER
PERIODICALLY AND REPLACE AS REQUIRED.
INSTALLING THE DISPOSABLE FILTER BAG:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL
OUTLET BEFORE REMOVING
THE TANK COVER.
34. Use the disposable filter bag in conjunction with the
cartridge filter for easy disposal of the debris. The bag
is not required for normal dry pick up. When picking up
fine dust or powders a high efficiency filter bag must
be used.
NOTE: Use for dry pick up only.
35. With cord disconnected from the receptacle, pull
latches in an outward motion and remove the tank
cover.
36. Unscrew hose locking-nut and
remove hose from inlet.
FIGURE 30.
FIGURE 30
37. Remove the inlet deflector from
the deflector guide. NOTE: Hose
must be removed before the inlet
deflector can be taken out.
FIGURE 31.
FIGURE 31
PAGE 9
PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
38. Position the inlet deflector with
the opening facing the left or the
right side of the filter bag. Slide the
filter bag collar over the inlet deflec-
tor, matching the notches of the bag
collar to the tabs on the inlet
FIGURE 32
deflector. Bag will only fit properly
one way. FIGURE 32.
39. Slide the inlet deflector with the
filter bag attached into the deflector
guide. FIGURE 33.
FIGURE 33
40. Reinsert hose into inlet and
tighten the locking-nut.
FIGURE 34.
FIGURE 34
41. When secured in place, expand the filter bag and
position around the inside of the tank. Replace tank
cover.
NOTE: When removing filter bag from tank, remove the
inlet deflector from the filter bag collar. Reinstall inlet
deflector into deflector guide. Inlet deflector must be in
place for any type of cleaning.
WARNING!
FOR FINE DUST POWDERS
When vacuuming fine dust, or powders of
any kind (plaster, drywall dust, cold ashes,
concrete dust, etc.) a high efficiency
drywall filter bag must be used. When vacuuming
normal household dust and debris, standard household
disposable filter bags may be used.
WET PICK UP
OPERATION
42. Your vacuum can be used for wet pick up. Remove
ALL dirt and debris found in the tank. Remove all
dry use only filters, including the filter bag, from the
vacuum.
43. A clean cartridge filter may be used to pick up small
quantities of liquid. To use the cartridge filter; follow the
cleaning and installation instructions under dry pick up.
Dynabrade, Inc. 8989 Sheridan Drive
|
Clarence, New York 14031
|
dynabrade.com