Hi-Z Antennas Shack Switch-2 Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} Hi-Z Antennas Shack Switch-2. Hi-Z Antennas Shack Switch-2 12 pagina's. Receiving array controller with an oled display

Pagina afdrukken

Hi-Z Receiving Array Shack Switch Using an OLED Display

Assuming you are ready to install the SS2, go ahead and connect the 12 Volt

supply at this time and also the CTRL lines coming from the array. Connect the USB

power and watch the new controller initialize and become active for direction control. If

you did not select your intended array to control in the previous steps, depress the

direction control knob and select your array now using the previous description or the

description below for the programming directions that ends with a knob depress. You

should be able to control your array's direction easily at this point using the direction

control knob.

4. Programming

All basic programming of the HIZ-SS2 begins with a push of the direction control knob

and ends with the same push after making a selection. All the programming functions

below assume the SS2 has been powered up either by a USB supply or a computer. All

programming will remain in effect when the controller is powered off and it will return

when the power is restored.

Here is an example using the Hi-Z Knob for a programming sequence.

Direction Screen

4.1.

Set Antenna Type

First, push the Hi-Z knob which brings up the directories of all the

programming functions. Rotate the Hi-Z knob until

screen. Depress the Hi-Z knob again and you will see one of the Hi-Z arrays description

displayed. Rotate the knob until you see the correct array you are programming the

controller for. Depress the knob again and the array will be set into memory and the

Set Antenna Screen

Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019

Set Antenna Screen

"Set Antenna

Back to Direction Screen

Type" is viewed on the