DYNACO ST400RCAJ Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} DYNACO ST400RCAJ. DYNACO ST400RCAJ 12 pagina's. Replacement rca jack

You'll note that the tops of the new RCA jacks project further than the old ones by about

1/8". This may allow the use of a wider range of RCA jack style for making input

connections.

Section 6: Reassembling the ST400

Reverse the procedure used to disassemble the ST400 to reassemble it. Briefly:

1. Carefully wiggle the heatsink assembly back into position in the chassis. Be

careful not to bend components as you work it back into place. Depending upon

your preferences:

a. You may find that it's easier to set the amp on its feet so that gravity could

help guide the heat sinks assembly back into place. Then insert the 4 side

screws in place before turning the amp vertical again to re-install the 9

bottom screws.

b. Alternatively, you may find it easier to leave the amp vertical with its

transformer side down, and re-install the 9 bottom screws, then set the

amp horizontal to reinstall the four side screws.

2. Reinstall the screws that hold the transformer shield to the heatsink.

3. Reinstall the perforated black cover.

4. Return your ST400 to service in your system.

Page 12 of 12