DynaColor 960H H.264 DVR Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} DynaColor 960H H.264 DVR. DynaColor 960H H.264 DVR 12 pagina's.

Dome Camera Control

Dome Camera Connection & Settings:

 See section Pin Definition of Alarm I/O & RS-485, and Audio for RS-485 port pin definition.

 Refer to the following figure. Connect the R+, R- terminals on the dome camera to the RS-485

D+, D- terminals on the DVR by RS-485 cable respectively.

4CH models:

8CH models:

16CH models:

 To set up dome the protocol and ID of the camera, click on MENU to access the OSD main

menu, and select <Camera>. Then select <Dome Protocol> and choose the corresponding

protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number

must match the ID address defined by the dome camera.

 To configure the RS-485 parameters, select <System> from OSD main menu, and then select

<RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and No

Parity.