CEL POWERstick Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CEL POWERstick. CEL POWERstick 16 pagina's. 10.8v li-ion cordless powerstick

Pagina afdrukken

1. Battery and Charging

POWERstick Functions

The POWERstick contains the battery and operating controls. It attaches to each of the tools to

provide a telescopic handle and comfortable work position.

WARNING

Do not allow contact with fire or water, it could cause an explosion!

Do not use an extension cord when charging.

Charge indoors only.

Please dispose of batteries at your local battery disposal depot.

To prevent explosion only use the provided charger.

Tool Release

Lower Tube

Catch

Blade Hangar

Tool

Adjusting the length of the telescopic arm is done by lifting the release catch and sliding the lower tube into the

desired position. Lock in place by returning the release catch to its original position where it will clip into place.

To alter the position of the control handle first rotate the locking knob 3 or 4 turns anti clockwise to release the

locking teeth, position the handle as desired and tighten the knob. The locking teeth can be worn down if the handle

is not tightened correctly or the handle is forced to move without loosening the knob enough.

To fit or remove a Tool grip the POWERhandle firmly behind the blade hangar to prevent your hand being trapped

in the mechanism. Hold the tool firmly by the upper section near the tool release catch and align with the

POWERhandle. The tools can only be fitted together in the correct orientation because the tube is shaped in a

specific way. DO NOT force the tool, if it is difficult to assemble re-align and try again. Press the lower tube into the

tool so that it locks into place against the blade hangar. You may notice the tool release catch click as it locks in.

To remove, press the tool release catch down and slide out, taking care not to swing the tool and hit a bystander.

After fitting a tool the trigger and safety catch will feed power to that tool and allow a great range of functions. To

operate the trigger you must first press the safety catch in from either the left or right side of the handle. Then,

ensuring no danger to yourself or bystanders press the trigger to operate the tool.

Release Catch

Control Handle

Locking Knob

Safety Catch

Operation Trigger

Charge Point

with Safety Cap

3.0