GREAT PLANES Seawind EP Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES Seawind EP. GREAT PLANES Seawind EP 20 pagina's.

❏

10. Fit one of the spinners all the way onto the propeller

and collet assembly. Adjust the cowl so there will be an

approximately 1/16" [1.5mm] gap between the spinner and

the cowl.

❏

11. Drill a 1/16" [1.6mm] hole trough the cowl and the

cowl mounting block 1/2" [13mm] ahead of the pin in the top

of the motor pod–this should put the screw hole right in the

middle of the cowl mounting block. Screw in one of the three

larger wood screws that came with this kit.

❏

12. Drill the holes for the remaining two cowl mounting

screws and insert the screws. Remove the pins.

Later, after the model has been completely ﬁ nished, the

spinner will be glued to the prop washer with a dab of

RTV silicone or white glue.

Mount the Horizontal Stabilizer & Fin

❏

1. Temporarily mount the wing to the fuselage. With the

plane resting in its building cradle, measure the distance

from the bottom of both wing tips down to your workbench.

Adjust the plane in the cradle until both distances are equal.

❏

2. Test ﬁ t the horizontal stabilizer (stab) into the fuselage.

Center it as best as you can by eye. Same as you measured

the distance from the wings down to the workbench, measure

the distance from both stab tips down to the workbench. If

the distances are not equal, place a small amount of weight

on the "high side" of the stab until you can get it level–use

coins or the stick-on lead weight you will be using to balance

the model later. This is how much weight will have to be used

when actually gluing the stab into the fuse.

Note: It's best to glue the horizontal stabilizer into the

fuselage with slow-setting glue such as epoxy, waterproof

white glue or R/C-56 so that there will be time to accurately

position and center the stab before the glue dries.

❏

3. Apply glue to the un painted area on the top and bottom

of the stab. Slide the stab into position and wipe off any

excess glue. Proceed immediately to the next step.

❏

4. Taking accurate measurements, center the stab in the

fuselage from side-to-side.

7 7