GREAT PLANES synapse arf Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GREAT PLANES synapse arf. GREAT PLANES synapse arf 12 pagina's.

❏

5. Cut three arms from two four-armed servo arms. Enlarge

the outer holes in the servo arms with a 1/16" [1.6mm] drill bit.

❏

6. Attach a pushrod wire with a Z-bend at one end to

the outer hole of each servo arm. Secure the servo arms to

the servos parallel to the elevon hinge line using the servo

arm screws included with the servos. Attach a screw-lock

pushrod connector to each control horn using a screw-lock

pushrod connector retainer.

❏

7. Insert the other end of the pushrod wires into the screw-

lock pushrod connectors. Position the elevons in the neutral

position and thread a knurled thumb screw into the screw-lock

connectors. Tighten the screws against the pushrod wires.

❏

8. Attach 2mm female to 3.5mm male bullet adapters (not

included) to the leads on the brushless motor. Mix up a small

batch of 6-minute epoxy. Brush on a thin coat of epoxy inside

the duct channel between the mold lines for the ducted fan

unit. From the top of the plane, feed the motor leads on the

ESC through the same hole that the servo wires use and

connect the leads to the motor. Conﬁ rm that the servo leads

are still positioned in the grooves in the duct channel. Fit

the ducted fan unit into position at the mold lines. The motor

leads should ﬁ t into the notch just behind the hole that they

pass through. We suggest holding the ducted fan unit tightly

in place as the epoxy begins the hardening process.

❏

9. After your model is assembled, the only way to remove

the ducted fan unit in case of repair or replacement is to cut