HiB Vector Handmatig - Pagina 2
Blader online of download pdf Handmatig voor {categorie_naam} HiB Vector. HiB Vector 4 pagina's.
Pagina afdrukken
Fixing Preparation (Fig A)
Fixing Brackets (Fig B)
Wall Hung Installation
1. Position the cabinet in a suitable location
(according to the zonal diagram (Fig 1) on
the back page) ensuring that the mains
supply cable is within reach of the cable
connection point of the cabinet. Carefully
mark the desired position of the cabinet
using a soft pencil, ensuring it is level.
2. Remove the cabinet from the wall and
using a spirit level, mark a horizontal line
below the pencil mark, taking into account
the location of the mounting points (Fig.
A). Place brackets on the new line paying
attention to the distance between the
hangers on the cabinet. Carefully mark the
position of the holes using a soft pencil.
(Fig. B).
3. Before drilling, ensure there are no hidden
cables or pipes behind the mounting point.
Using a suitable drill bit, drill holes in the
marked positions to a suitable depth.
4. Insert wall plugs level with the surface of the
wall. If fitting to a tiled surface, wall plugs
should be inserted below the tile surface to
avoid cracking. NB. For plasterboard walls,
2
REAR VIEW
Mounting Points
location of internal
fixing hole
Hanger Adjustment (Fig C)
specialist fixings should be purchased from any
DIY or hardware store.
5. Fix the brackets to the wall using the screws
provided.
6. Carefully remove the small screws along the
top front edge of the cabinet to gain access
to the internal panel(s). (Fig. C) Keep screws
in a safe place.
7. Temporarily hang the cabinet ensuring the
claws on the hangers are securely located on
the wall brackets. Using a spirit level adjust
the cabinet via the screws on the hangers.
8. Mark the position of the internal fixing hole
and remove the cabinet. Using a suitable drill
bit, drill a hole and insert a wall plug as per
stage 4.
9. Connect the cable at the rear of the cabinet
to the mains supply cable using a suitable
terminal block (not supplied) according to
the wiring diagram (Fig. 2) on the back page.
10. Rehang the cabinet in position, tighten the
screws on the hangers (Fig. C) and secure the
base of the cabinet with the supplied screw
and screw cap.
Angle Adjustment
Claw In/Out
Claw In/Out
Adjustment
Adjustment