Automated Logic UNI/32 Technische instructies - Pagina 7

Blader online of download pdf Technische instructies voor {categorie_naam} Automated Logic UNI/32. Automated Logic UNI/32 10 pagina's.

Pagina afdrukken

NOTE Since a failed download indicates

a system problem, you should never clear

a failure. Locate and resolve the problem,

then retry the download.

6. Click the Properties button to refresh the

screen. This removes the items from the

Download Items list.

Transferring Memory in SuperVision

If you are using SuperVision to transfer

memory, you must use SuperVision version

2.6b or later, FBLINK version 2.7a or later, and

the UNM module driver. For more information

about using SuperVision, refer to the

SuperVision User's Guide.

The first memory transfer to the UNI/32 takes

longer than subsequent memory transfers.

1. Connect your workstation or portable

computer to the UNI/32. Refer to

"Communicating with the Workstation

Using SuperVision" on page 8.

2. Navigate to the module driver and look at

the module status report in SuperVision to

make sure the module type and number

agree with the module.

• To view the module status report in

SuperVision v3.0, click Tools-

Troubleshooting-Module Status.

• To view the module status report in

SuperVision v2.6b, press the Esc key,

type MO

, , module address,15

and press Enter.

3. Transfer memory to the module.

• In SuperVision v3.0, click Tools-

Troubleshooting-Transfer Memory to

Module.

• In SuperVision v2.6b, choose Download

Memory for This Module.

4. When the memory transfer is finished,

check the module status report again.

Revised 11/26/01 • UNI/32

Make sure the FB List on this page shows

all the FBs you intended to transfer.

Using Flow Sensors

The UNI/32 supports U-cards that use flow

sensors. You must calibrate each sensor to

ensure accurate readings. You must also set

the type of U-cards and flow sensors that are

being used by each FB on the module driver

Properties page in WebCTRL or Parameter

page in SuperVision.

• If you are running a WebCTRL system,

configure the type of U-card and flow

sensor on the Airflow microblock

Properties page for each FB that uses a

flow sensor. Refer to the DRV_UNI16

and DRV_UNI32 Module Driver

document for details.

• If you are running a SuperVision

system, configure the type of U-card

and air sources on the module driver

Parameter page. Refer to the UNM

Module Driver document for details.

For more information on calibrating,

see the Test and Balance Technical

Instructions.

Troubleshooting Tips

If you are having trouble communicating with

the UNI/32, check these items before

contacting Technical Support.

• Make sure the U-Line wiring is correct.

In more complex systems, make sure

that all cables involved are attached

correctly.

• Make sure the UNI/32 and the U-cards

have power and are turned on. In more

complex systems, make sure all

equipment has power and is turned on.

Some devices, especially

communication devices, receive power

from a source other than a power cable

or adapter (for example, some devices