Automated Pet Care Products LITTER-ROBOT Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Automated Pet Care Products LITTER-ROBOT. Automated Pet Care Products LITTER-ROBOT 19 pagina's. Self-cleaning litter box
Ook voor Automated Pet Care Products LITTER-ROBOT: Handmatig (16 pagina's), Handmatig (18 pagina's)

Pagina afdrukken

Filling through the entrance opening

Make sure that the Globe is in the home position.

Scoop approximately 9 lbs or 1½ gallons of litter

(whichever is less) into the Globe through the cat

entry/exit opening.

With the Globe in the home position, the litter level

should not be higher than about 2 inches below the

bottom rim of the cat entrance opening.

After adding litter to the Litter-Robot you can start

a cleaning cycle by pressing the "Cycle" button on

the Control Panel. Any excess litter will be dumped

into the waste drawer. At the end of the cycle the

litter bed will be leveled.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Filling through the waste ports (square holes)

First, make sure that the Globe is in the home

position. Look through the Cat Entry opening and

locate the ribbed handle of the Internal Guard

inside the Globe, on the right. Grab this handle and

rotate it upward (clockwise) until it snaps into a

horizontal and locked position (see figure). Note

that the pin on the opposite side of the globe

should be locked behind the spring as shown below.

Locate Internal

Rotate handle upward

Guard handle

until it locks

Next, press the "Fill" button on the Control Panel.

This starts the Globe's rotation, bringing the waste

ports to the top - a position convenient for filling.

Pour approximately 9 lbs or 1½ gallons of litter

(whichever is less) through the square waste ports

in the Globe, If you over-fill, the excess litter will

be expelled during the first few cleaning cycles.

Note that you may want to use a towel to cover the

cat entry/exit opening when filling through the

waste ports as it will help reduce dust kicked up

during the filling process.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Rear View

Pin Locks behind

spring