Dynacord DMM 4650 Technische informatie - Pagina 10

Blader online of download pdf Technische informatie voor {categorie_naam} Dynacord DMM 4650. Dynacord DMM 4650 19 pagina's. Signal processor

Pagina afdrukken

Press the indicated cursor key to have the "1" blink.

Press the indicated cursor key to select relay 2.

This completes the programming of the relay contact 2

of port A (set). The result is the lighting of an externally

connected lamp whenever your sequence is started.

Press the indicated cursor key three times to have the

"1" blink.

Pressing the indicated cursor key displays step 2 which

stays unchanged (disables the master input during the

message is outputted).

Pressing the indicated cursor key displays step 3 which

stays unchanged (sets the message's volume).

Pressing the indicated cursor key displays step 4 which

activates the reproduction of the message "M01".

Pressing the indicated cursor key four times sets the

blinking cursor to the "1".

Pressing the indicated cursor key twice selects message

03. This starts the reproduction of your previously

recorded message "M03".

Press the indicated cursor key displays twice to have the

"4" blink.

Pressing the indicated cursor key displays step 5 which

stays unchanged (wait for the end of the message).

Pressing the indicated cursor key displays step 6 which

stays unchanged. This is also the last step of the

procedure.

When you press the "EXIT" button, the question

"save?" appears on the display.

Press the indicated cursor key repeatedly until the

display reads the required sequence number (S03).

Pressing the soft key "yes" stores your new sequence-

listing as preset S03 into memory.

steplist

1:OutA.1 set

steplist

1:OutA.2 set

steplist

1:OutA.2 set

steplist

2:Sum=off

steplist

3:DMM= -2dB

steplist

4:Start M01

steplist

4:Start M01

steplist

4:Start M03

steplist

4:Start M03

steplist

5:wt Audio

steplist

6:End

Sequ save

EXIT

Sequ save

to S27

to S03