Dynacord DMM 4650 Technische informatie - Pagina 15

Blader online of download pdf Technische informatie voor {categorie_naam} Dynacord DMM 4650. Dynacord DMM 4650 19 pagina's. Signal processor

Pagina afdrukken
Pressing the indicated cursor key displays step 4 which
stays unchanged (relay contact B2 for obligatory
reception activated).
Pressing the indicated cursor key displays step 5 which
stays unchanged (relay contact B3 for obligatory
reception activated).
Pressing the indicated cursor key displays step 6 which
stays unchanged (relay contact A4 for control lamp
"outgoing gong signal).
Pressing the indicated cursor key displays step 7 which
stays unchanged (switches the master input during the
reproduction of the gong signals off).
Pressing the indicated cursor key displays step 8 which
stays unchanged (setting the volume of the gong
signals).
Pressing the indicated cursor key displays step 9. This
step normally would trigger the start of the gong signal
G20.
Press the indicated key four times to set the displayed
value under the blinking cursor mark to "0".
Press the indicated cursor key to select the gong signal
G21. This step activates the desired gong signal.
Press the indicated key twice to have the value "9" blink.
Pressing the indicated cursor key displays step 10 which
stays unchanged (wait for the gong signal to fade out).
Pressing the indicated cursor key displays step 11 which
stays unchanged. This is also the last step of the
procedure.
When you press the "EXIT" button, the question "save?"
appears on the display.
Press the indicated cursor key repeatedly until the
display reads the required sequence number (S05).
Pressing the soft key "yes" stores your new sequence-
listing as preset S05 into memory.
After showing a short message that
storing was successful, the display
returns to the start-screen of the
sequence.
Ù
×
Ú
Ù
×
Ú
Ù
×
Ú
Ù
×
Ú
Ù
×
Ú
Ù
×
Ú
Ù
×
4x
Ú
Ù
×
Ú
Ù
×
2x
Ú
Ù
×
Ú
Ù
×
Ú
EXIT
Ù
×
Ú
Sequence
saved
steplist
Ø
4:OutB.2 set
steplist
Ø
5:OutB.3 set
steplist
Ø
6:OutA.4 set
steplist
Ø
7:Sum=off
steplist
Ø
8:DMM= -2dB
steplist
Ø
9:Start G20
steplist
Ø
9:Start G20
steplist
Ø
9:Start G21
steplist
Ø
9:Start G21
steplist
Ø
10:wt Audio
steplist
Ø
11:End
Sequ save
to S25
Sequ save
Ø
to S05
Sequ save
to S05
Sequence
steplist
d
i
d
i
d
i
d
i
d
i
d
i
d
i
d
i
d
i
d
i
d
i
y
n
y
n
y
n
ok