Dynacord PowerSub 312 Gebruikershandleiding - Pagina 15
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynacord PowerSub 312. Dynacord PowerSub 312 20 pagina's. Powered 3-channel subwoofer
Ook voor Dynacord PowerSub 312: Architecten en ingenieurs specificaties (2 pagina's)
Pagina afdrukken
X-OVER
This switch allows changing the x-over frequency between subwoofer
and satellites. During normal operation this switch should be left at the
100Hz setting. Set the x-over switch to 140 Hz when using compact
satellite cabinets, e.g. VL62. For large-size cabinets, e.g. D12, set it to
70 Hz.
SUB LEVEL
This control sets the output volume of the PowerSub 312 in a range
between -dB and +10dB. The center position represents 0dB.
POWER switch
Mains switch for switching the unit's power ON or OFF. The mains switch lights after
switching on the PowerSub 312. In case the switch is not lit upon switching on the
power, make sure that the mains cord is connected correctly. If this is the case and
the PowerSub 312 still shows no function, please contact your local dealer.
MAINS IN
The mains connector is carried out as a PowerCon socket. A suitable 5m long
mains cord with PowerCon plug is supplied.
SPEAKER OUTPUTS
These outputs are for connecting the satellite
cabinets, e.g. Dynacord D8. Each output has an
output capacity of up to 250W into 4 ohms.
In other words, up to two loudspeaker systems with
8 ohms impedance can be connected in parallel per
output.
EXTERNAL SUB OUTPUT
This output allows connecting an additional passive
subwoofer, e.g. SUB 112. Maximum output capacity
is 400W into 8 ohms.
15
CONTROLS