Automatic CS184-A Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Automatic CS184-A. Automatic CS184-A 16 pagina's. 1500w 184mm (7 1/4”)

Making a pocket cut

1. Adjust the depth of cut as required.

2. Adjust the bevel setting to 0°.

3. Raise the lower blade guard

lever to expose the saw blade

and firmly rest the front of

the base flat against the work

piece with the rear handle

raised so the blade does not

touch the work piece (Fig. K).

4. With the blade just clearing

the work piece, start the motor by depressing the lock-off

button and squeezing the trigger switch.

5. Always let the blade reach full speed (approximately

2 seconds) before you begin to cut into the work piece.

6. Slowly lower the saw into the work piece, using the front

of the base resting on the work piece as a hinge point.

WARNING. As soon as the blade starts cutting the material,

release the lower blade guard lever.

7. Once the base plate is flat against the work piece,

proceed cutting in a forward direction to the end of

the cut.

8. After completing your cut, release the trigger switch

and allow the blade to come to a complete stop.

Do not remove the saw from the work piece while the

blade is moving.

Note. If the corners of your pocket cut are not completely

cut through, use a jigsaw or hand saw to finish the corners.

The parallel fence allows you to make parallel cuts

in a sheet of wood, all at the same width.

CAUTION. Always ensure that the saw is switched off

and unplugged from the power supply before making

any adjustments.

1. Loosen the parallel fence locking wing nut (Fig. L).

2. Slide the parallel fence through the parallel fence slots in

the base plate (Fig. M).

3. Adjust the parallel fence to the required width and secure

it in position with the parallel fence locking wing nut.

(Fig. N).

4. Ensure that the parallel fence rests against the wood

along its entire length to give a consistent parallel cut.

(Fig. O).