Dynacord DMM 4650 Technische informatie - Pagina 7

Blader online of download pdf Technische informatie voor {categorie_naam} Dynacord DMM 4650. Dynacord DMM 4650 19 pagina's. Signal processor

Pagina afdrukken

Programming Examples for the DMM 4650

Page numbers within brackets (Sxxx) refer to the corresponding page of the DMM 4650's

user's manual.

The following examples are based on the assumption that the appliance's mode is set as follows:

Software revision 1.1 (page 22), the DMM 4650 is in the factory-preset mode (page 27 and page 36),

operation is performed in the user level 3 status (page 10).

Example 1

Intention:

Recording a message that later on is to be played back using a external key.

Summary

1. Recording a message (i. e. M03) in speech quality.

2. To include the reproduction of this message in an existing installation, an appropriate control

sequence has to be established that gets a priority between "fire alert" and "gong" (i. e. priority 90).

This sequence also activates an optical signal in form of a lit lamp for the period of the outgoing

message. To accomplish the task, this example uses the relay contact 2 of the port A (=A2).

3. An input, which at the moment is unused (i. e. B.4) had been connected to the "Start"-key (page

30). This input has to be programmed in the "Auslöser" (trigger) menu for that pressing the start

button activates the above mentioned sequence (S03).

Step By Step Programming

Enter the password for the user level 3 on the display,

using the four cursor keys (page 10) and confirm your

action with the "ok"-button.

If you have entered the correct password,

the display briefly shows this message and

then returns to the main menu.

After pressing this cursor key twice, the "Message"-

menu appears. Confirm your selection with the "ok"-

button.

On the display the message number 00 and the name

"Message" is shown. The numeric values mm=minutes

and ss=seconds equal the time of a message that

already exists in the register 00.

Pressing this cursor key three times displays the

required message register 03. The display shows the

name of the "empty" message 03.

Pressing the "record"-button displays a proposal

for the audio quality of the new recording (page

14). Using the soft key "ok" the proposition is

confirmed (speech quality).

On the display you are asked for the level setting (page

14). Since this is your first recording with the

microphone, the level has to be set a new. The

microphone has to be connected to the MIC-socket on

the front panel and pressing the soft key "yes", the

automatic adjustment process for the electronic control

is activated.

Dynacord DMM4650

Userlevel 3

Recording a message

I<< << >¨ O >> >>I

password?

****

Main-Menu

System-Setup

Main-Menu

Message

M00'Message ' vl

mm:ss.s

M03'

empty

record-mode

8kHz long

select new

recordlevel?

edt

' vl

edt