Daytona DS300SG Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Daytona DS300SG. Daytona DS300SG 13 pagina's. 3 ton heavy duty floor jack
Pagina afdrukken
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Removing Shipping Clip
CAUTION! The Handle socket may be held down by a clip under tension. Wear ANSI-
approved safety goggles before freeing Handle socket. Remove clip carefully.
A wire clip holds the Handle Socket in position during shipment. This helps prevents shipping damage. To remove it:
1. Press down on the Handle Socket to
relieve tension on the wire clip.
2. Disconnect the wire clip legs from the bar.
Attaching the Handle
1. Slide the Upper Handle into the Lower Handle.
Line the Button on the Lower Handle up with the
hole in the Upper Handle until it clicks into place.
Bleeding Trapped Air
1. With the Jack fully lowered, remove both Screws
on the end of the Cover Plate that is closer to the
Saddle. Swing the Cover Plate open. See Figure A.
2. Remove the Fill Plug on top of the Cylinder.
Check that the oil level inside the Cylinder is
at the top of the Piston. See Figure B.
3. Insert the Handle into the Handle Socket
to operate the Release Valve.
4. Turn the Handle counterclockwise to open the valve.
5. Pump the Handle up and down quickly
10-15 times to force air from the system.
6. Replace the Fill Plug, close the
Cover Plate, and reinstall the Screws.
Adding Oil
NOTICE: To prevent damage and premature wear,
use only 22 viscosity, non-detergent hydraulic jack oil.
1. With the Jack fully lowered, remove both Screws
on the end of the Cover Plate that is closer to
the Saddle. Swing the Cover Plate open.
2. Remove the Fill Plug on top of the Cylinder.
3. Add non-detergent 22 weight hydraulic jack oil
into the Fill Plug hole slowly until the oil level just
reaches the top of the Piston inside the Cylinder.
4. Replace the Fill Plug, close the
Cover Plate, and reinstall the Screws.
Page 6
For technical questions, please call 1-888-866-5797.
3. Slowly raise the Handle Socket
until tension is released.
4. Remove the wire clip.
2. Pull on the Handle Release and insert the grooved
end of the Handle into the Handle Socket.
3. Let go of the Handle Release. Gently pull up
on the Handle to make sure that it is secure.
Fill Plug
Figure A: Hydraulic Unit
Fill Plug
Oil
Piston
Cylinder
Figure B: Fill Level
Safety Valve Covers
Do not open or adjust.
FILL LEVEL
Item 64783