Automatic WTLD018 Gebruiksaanwijzing - Pagina 13

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Automatic WTLD018. Automatic WTLD018 16 pagina's. 20v drill/driver

Pagina afdrukken

Forward/reverse switch

Note. You can only change

the direction of rotation of the

drill using the forward/reverse

switch when the trigger is NOT

depressed.

This switch (4) will allow you to

change the direction of the motor

while the trigger switch is not

depressed.

Drilling uses the forward mode.

The reverse mode is intended

for the removal of screws and

assisting to remove jammed

drill bits.

Drill Overload

This drill is fitted with an

overload protection. If the drill is excessively forced, or the

task being performed is too great for the drill, the drill will

automatically go into an overload mode. When the drill goes

into overload, the drill will automatically and suddenly STOP.

To reset the overload, simply release the trigger. When the

trigger is pressed again, the drill will restart. Resume work

after the overload has been reset, but reduce the load by

using a smaller drill bit or re-sharpen the existing drill bit and

reduce the amount of force placed on the drill.

CAUTION. Do not continue to overload the drill and

constantly reset the overload. Doing this will cause the

battery cells to over heat.

Temperature Cut Out

If the drill is constantly overloaded, or the drill is used

constantly at maximum rating in high ambient conditions,

the battery cells may over heat causing the battery pack

to shut down.

When this occurs you will need to immediately stop drilling

and allow the battery cells to reduce the temperature.

To reduce the temperature of the cells remove the battery

pack from the drill and place the battery pack in a free air

environment, out of direct sunlight or any other heat source.

DO NOT force cool the pack in any way. Do not place in

refrigerators or freezers.

When the battery pack has cooled down it can again

be used to operate the drill, as long as the load or the

conditions causing the original excessive temperature

has been corrected.

Low voltage cut out

The battery pack used on this tool is fitted with a low

voltage cut out feature within the circuitry.

The low voltage cut out feature operates when the voltage

drops below a pre set value. This feature automatically

stops the drill from operating (similar to that of the over

load condition). When this condition occurs you will need

to either insert another battery into the drill or recharge the

existing battery.

The low voltage cut out feature has been added to

maximise the tools life. When this occurs, recharge the

battery pack by following the battery charging section in

this manual.

Note: Attempting to restart the tool without either recharging

the battery or installing another battery (with charge) will

lead to drill restarting and then stopping again, after only a

few seconds of operation.