HIBLOW hp-200 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} HIBLOW hp-200. HIBLOW hp-200 13 pagina's. Air pumps
Ook voor HIBLOW hp-200: Handmatig (8 pagina's), Gebruiksaanwijzing (17 pagina's)

Pagina afdrukken

EXTENSION CORDS

Use only a 3-wire extension cord that has a 3-blade grounding plug, and a 3-slot receptacle that will

accept the plug on the product. Make sure your extension cord is in good condition. When using an

extension cord, be sure to use one heavy enough to carry the current that your product will draw.

A cord no longer than 100 feet, No.16 AWG extension cord should be used. An undersized cord will

cause a drop in line voltage resulting in loss of power and overheating. For outdoor use, use an

extension cord that is approved for outdoor use, marked W-or W-A.

MOUNTING

CAUTION:

When using the pump to inject air into a liquid, make sure that the pump is higher

than the surface level of the liquid, otherwise that liquid may run back into the

pump if the power is interrupted.

The pump should be in an upright, level position and remain on a stable, rigid operating surface for

proper operation.

PLUMBING

Improper connection will cause leakage of air.

HP Series : Connect the pumps exhaust port and PVC(plastic)pipe with an L-shaped rubber hose.

Be sure to secure place of connection with a hose tightening clip(Refer to Fig.1).

Fig. 1

STORAGE

Store indoors out of the weather in a dry area. Make certain the electrical cord is placed so there will

be no chance of damage.

CAUTION:

To avoid risk of electrocution or damage to the pump do not store this unit where it

could come into contact with water or other liquids. Store indoors. Inspect

compressor and cord for damage prior to putting compressor back into service.

Pump's exhaust port

L-shaped rubber hose

Hose tightening clip

PVC

(Plastic) pipe