HiBoost Home 10K Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} HiBoost Home 10K. HiBoost Home 10K 20 pagina's. Mobile signal booster

to fully waterproof the connection.

Connect the indoor ontenno cables from your indoor antenna to the booster

connector morked "Indoor." Tighten the connection by hand.

(After you hove tested the system you con permonently secure the coaxial

cable).

As you route and pull cobling, follow these general guidelines:

- Bend cables and route them smoothly, and protect the outer skin against any

damage.

. Keep horizontol cobles straight and fosten them with 0 tie every three to five

feet.

. Bind dnd fdsten verticol cobles every six to eight feet.

- Woterproof oll connectors between outdoor antenna and coaxial cables with

waterproof tape to ovoid water or other kinds of damage.

. Be careful when plugging the connector in so as not to damage the center pins

on the connectors.

1.8 Power up your signal booster

Once all the following precoutions hove been token, power on the signal

booster.

1. Verify that you have left at least 20 feet of vertical sepdrotion space between

the indoor and outdoor ontennds.

2. Never point the front of outdoor ontenno towards the inside of the indoor

antenna.

3. Verify that the supplied coaxial cables from both the outdoor antenna and the

indoor antenna are properly connected to the signal booster before

powering it up.

4. Carefully plug in the supplied power adaptor into the signal booster where it

is marked 'DC 12V' and connect the other end to 0 power outlet.

The LED indicator morked power should light up green.

SIGNAL BOOSTER STATUS

Overview: The booster has 0 smort stortup system. When you have finished the

booster system installation and power on the booster, it will start its initiolizotion

process to check the received downlink signal from the cell site and the isolation

status. This on automatic process designed to ensure its best performance. This

will take approximately 3-5 seconds.

After the booster starts up, please check if the coverage is good. If it is good, the

booster system installation is complete. If the coverage is not adequate, pleose

fully reredd and understand the LCD, LED indicotions, control buttons, and MGC

function on your booster. These will help you identify and solve any potential

Issues.

9/18