Celerity FOG-TXCB Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Celerity FOG-TXCB. Celerity FOG-TXCB 8 pagina's. Fiber optic gateway (fog)

Installing the Fiber Optic Gateway

Paying close attention to the "direction" of the Celerity Fiber Optic Gateway cable, install the fiber optic cable

in the required pathway between the source components and the display components. At each end of the

Celerity FOG cable is a mini digital connector. Place the T labeled mini-connector at the source location.

Extend the fiber optic cable to the display (R). The Celerity Fiber Optic mini digital connectors are clearly

marked for T (source) and R (display) and must be installed correctly.

Determine the placement of the FOG-TXCB at the source (transmitting) location; securely attach the FOG-TX-

CB as required using the mounting flanges (included) and appropriate screws matching the mounting surface

(not included). Position the FOG-TXCB for clear access to the connector panel and the Celerity Fiber Optic

Gateway cable mini digital connector. The connector markings have been conveniently placed on the top

surface of the FOG-TX/RXCB to provide easy viewing. Follow similar procedures for installing the FOG-RXCB

at the receiving location.

NOTE:

Pay particular attention to the TX (TX = source) and RX (RX = display) designations. The FOG-TX-

CB should be located with the source components (Main equipment rack, Blu-ray,set-top box etc) and the

FOG-RXCB should be located with the display components (HDTV, etc).

NOTE:

Celerity Fiber Optic Gateway cable is not compatible with Celerity Fiber Optic HDMI

Detachable Connectors.

LED Display Indicators

On the top surface of the FOG-TXCB and FOG-RXCB are blue and orange LEDs which will illuminate when

the cables are correctly connected. The LED for the Fiber Optic Cable connection will illuminate with the

cables connected in the proper direction and the FOG-CB are powered. If the blue LED does not illuminate

ensure that the fiber optic cable is installed in the proper direction and correctly matched at the Fiber Optic

Gateway (ie. T connected to T and R connected to R) and the power is connected (a blue LED will illuminate

above the power connection when power is activated).

User Guide

09/2014