GAI-Tronics 354-700YL Handmatig - Pagina 11

Blader online of download pdf Handmatig voor {categorie_naam} GAI-Tronics 354-700YL. GAI-Tronics 354-700YL 17 pagina's. 354-70x series nema 4x voip telephone

GAI-Tronics 354-700YL Handmatig
NEMA 4X VoIP Telephones
Programming
The installer should ensure that the network is configured to allow VoIP communications (using the SIP
protocol) between the desired locations before attempting to configure GAI-Tronics VoIP Telephones.
VoIP PCBA Setup
Verify the PC is connected to the same network as the VoIP telephone.
The easiest way to get started is to make a network connection to the unit and log on via a web browser.
The unit is initially set with a static IP address:
IP address
192.168.1.2
A user name and password will be requested. The initial factory settings are:
User Name
user
Password
password
Changing the user name and password is recommended. This security measure helps to prevent
unauthorized changes to the VoIP telephone interface's configuration.
VoIP PCBA Initial Network Configuration
Each VoIP PCBA must be set up for the network prior to installation. Assign a local ID, domain, proxy,
and registrar.
Assign a host name
The host name provides identification of the different VoIP PCBAs on the
network.
Test
Verify that calls can be made successfully.
Maintain
Monitor alarms. Set up auto-updates.
Refer to Pub. 42004-481 VoIP Telephone Configuration Guide for detailed programming instructions for
this VoIP device.
Alternative Configuration Methods
There are three methods for configuring GAI-Tronics Handset VoIP telephones:
Web pages
Configuration file
Command Line Interface (CLI)
Web pages (held within the telephone) can be accessed over the network using a browser such as Internet
Explorer™, to view and change settings within a single unit.
Configuration files are ASCII text files containing configuration options that can be read and edited by a
knowledgeable user. The telephone can automatically download a configuration file from the network,
providing a controlled method of configuring multiple telephones.
The telephone can also be configured using a command line interface, either via the local serial port or
remotely via a TELNET session over the network.
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-520A.docx
03/17
Pub. 42004-520A
Page 11 of 15