Greatneck 80154 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Greatneck 80154. Greatneck 80154 16 pagina's. 3/8" drill

Pagina afdrukken

TRIGGER SWITCH – cont'd

Fig. 2

TRIGGER SWITCH LOCK

The trigger switch lock-on feature allows

the trigger switch to be locked in the ON

position when continuous operation for

extended periods of time is required (see

Fig. 3).

To lock the trigger switch in the ON

position, pull back on the trigger switch (1)

to start the drill and push the trigger switch

lock button (2) into the drill handle. Release

the trigger switch while holding the trigger

switch lock button into the drill handle. The

drill will continue to run. To release the

trigger switch lock button, pull trigger switch

back and then release the trigger.

ASSEMBLY & OPERATION

INSTALLING DRILL BITS

WARNING:

body with one hand and use the drill

power to rotate the drill body to loosen

or tighten bits. Serious injury may

result.

To open the keyless drill chuck, grasp

the chuck body (1) and the chuck collar

(2) with the other hand. Rotate the

chuck body in a counter-clockwise

direction (3) until the chuck jaws (4)

open wide enough to accept the bit

(see Fig. 4).

Insert bit (5) into the chuck the full

length of the jaws (4). Raise the front

of your drill slightly to prevent the bit

from falling out of the chuck jaws.

Tighten the chuck jaws onto the bit by

holding the chuck collar (2) with one

hand and turning the chuck body (1) in

a clockwise direction.

NOTE: Make sure the bit is properly

aligned in the jaws and NOT at an

angle. An improperly aligned bit could

be thrown from the chuck when the drill

is started. Make sure the chuck jaws

grasp the flat sides of a screwdriver bit.

Fig. 3

Never hold the chuck