Greatneck 80160 Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Greatneck 80160. Greatneck 80160 20 pagina's. Variable speed jigsaw

Pagina afdrukken

BEVEL CUTTING

Bevel cutting angles may be adjusted

from zero to 45° either left or right. To

adjust the bevel angle:

Loosen both sole plate pivot screws

(1) until the sole plate (2) can be

rotated

(Fig. 5).

NOTE: Use the 3 mm hex key

supplied.

Bevel angles (3) are marked on a

scale located on the side of the sole

plate (Fig. 6).

Slide the sole plate back. Align the

edge of the motor housing (4) with the

desired angle mark (3) on the side of

the base, then slide the sole plate

forward to engage the notches (5) into

the motor housing pin.

OPERATION

ig. 5

Fig. 6

BEVEL CUTTING - cont'd

NOTE: Angle marks on the sides of the

jigsaw base are for reference only.

Operator should use a protractor to verify

angles.

Once the desired bevel angle is

obtained, lock the sole plate by

tightening the sole plate pivot screws.

Make a test cut in a scrap piece of

material and measure the bevel angle.

Adjust bevel angle if necessary.

PLUNGE CUTTING

WARNING:

control, broken blades or damage to the

workpiece, always use extreme caution

when making plunge cuts. It is not

recommended to plunge cut any

material other than wood. Wherever

possible, drill a 3/8" (8 mm) or bigger

pilot hole in the area to be cut out and

start cutting with the blade in the pilot

hole. This will avoid the need to plunge

cut.

NOTE: Use only blades with 7 teeth per

inch for plunge cutting.

To plunge cut an inside hole, clearly

mark the cutting line on the workpiece.

Set the bevel angle at 0° then lock the

sole plate.

Tilt the saw forward so it rests on the

front edge of the sole plate and in a

position so the blade will NOT touch

the workpiece when the switch is

turned ON (Fig. 7).

NOTE: Make sure the saw blade is

inside the area to be cut.

To avoid loss of