Automatic Technology GDO-6 EasyRoller Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Automatic Technology GDO-6 EasyRoller. Automatic Technology GDO-6 EasyRoller 20 pagina's. Rolling door openers
Ook voor Automatic Technology GDO-6 EasyRoller: Installatie-instructies (2 pagina's), Beknopte handleiding (6 pagina's)

Pagina afdrukken

GDO-6 EasyRoller

8. Coding Transmitters

8.1 Setting the Transmitter to Operate the Door

The opener can only operate from transmitters that have

been programmed into its receiver. The receiver needs to

learn the codes of any transmitter that will be used with the

operator. Up to sixty four (64) codes can be stored in the

receiver's memory.

a. Ensure the button cover has been removed (see

Electrocution caution) and the opener is turned on.

b. Press and hold the DOOR CODE button. The DOOR

CODE LED will illuminate and beep to indicate the

opener is in Code Learn mode

c. Press and hold the transmitter button that you want to

control the door for two (2) seconds, pause for two (2)

seconds, then press the same button again for two (2)

seconds and release.

d. Release the DOOR CODE button.

e. Press the transmitter button to test.

8.2 Setting the Transmitter to Operate

Vacation Mode

The opener can be programmed into a "Vacation Mode"

where the opener will not respond to any transmitter

except one preprogrammed unit.

f. Briefly press the DOOR CODE button once, then press

it again and hold (will beep two times on second press

(Fig.

8.2).

g. Press one of the four (4) buttons on the transmitter for

two (2) seconds, pause for two (2) seconds, then press

the same button again for two (2) seconds.

h. Release DOOR CODE button.

i. Press and hold the transmitter button for six (6)

seconds to set Vacation Mode. The door code LED

will stay lit while Vacation Mode is active.

To reset Vacation Mode, press the same transmitter

button for two seconds.

8.3 Setting the Transmitter to Operate

PET (Pedestrian) Mode

a. Briefly press the DOOR CODE button three (3) times,

then press it again and hold (the opener will beep four

times on the fourth press.

b. Choose a transmitter button not already coded into

the receiver. Press and hold this button for two (2)

seconds, pause for two (2) seconds, then press the

same button again for two (2) seconds and release.

c. Release the DOOR CODE button.

d. Press the transmitter button to test.

Home Owner's Manual

(Fig.

8.1).

ELECTROCUTION! The button

cover is the only cover that should

be removed. All other covers must

remain in place.

CAUTION: Be careful not to press

the operate button while removing

the button cover as the door will

start to move.

IMPORTANT NOTE: Only TrioCode

Technology Transmitters are compatible

with this GDO-6V4 product.

Press and hold DOOR

CODE button once

Select one of the four buttons on

key transmitter you wish to use to

control the door. Or the button on

the end of the manual release cord.

Fig. 8.1

Illuminated

LED

indicates

mode is active

Press DOOR

CODE button

twice.

Fig. 8.2

128

Select one of the

four buttons (not

programmed yet

) you wish to use

to control the

Vacation Mode