GAI-Tronics 10959-903 Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} GAI-Tronics 10959-903. GAI-Tronics 10959-903 20 pagina's. Audio control center hard-wired system interconnection w/ radio access
Ook voor GAI-Tronics 10959-903: Handmatig (6 pagina's)

Pagina afdrukken

Models 10959-903 and 10959-904 Wall-Mount Audio Messenger Interface

Time Set Up

Use the push buttons located on the top edge of the main PCBA to set the time. Complete the following

procedure to set the time:

1. Press <ENTER>, PB4, to enter the menu system.

2. Press <SELECT>, PB3, to scroll to the TIME: display.

3. Press <ENTER>, PB4, to enter the TIME: set up.

4. Press <ENTER>, PB4, to confirm choice.

5. Press <UP>, PB1 or <DOWN>, PB2 to select the desired hour.

6. Press <SELECT>, PB3, to scroll to the minute.

7. Press <UP>, PB1 or <DOWN>, PB2 to select the desired minute.

8. Press <ENTER>, PB4, to accept the TIME: setting.

ACT (AMI Configuration Tool)

Overview

The ACT (AMI Configuration Tool) software is used to define and change configurations for the AMI,

and is included with the unit. The AMI accesses a CompactFlash

with the 10959-903 or 10959-904 product configuration to retrieve configurations and play audio

messages.

Please refer to the ACT software online help for specific instructions.

System Requirements

The ACT software must be installed on a Windows PC (Windows

A reader/writer capable of programming CompactFlash

port. The CompactFlash

CompactFlash

The CompactFlash

memory card stores the system configuration, speech messages, and alarm tones.

Complete the following instructions to install the memory card:

1. Insert the memory card through the rectangular MEMORY CARD slot on the AMI main board with

the label on the memory card facing up.

2. Slide the memory card in until it is fully seated in the slot.

When seated properly, the card protrudes approximately ¼ inch from the front of the socket.

: The memory card and its socket are keyed for proper insertion—do not force the card into the

OTE

socket.

3. Reboot the system so the AMI unit can read the memory card.

P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-442D.docx

10/18

reader/writer is not included with the AMI.

memory card that is pre-programmed

XP/7/10) equipped with a USB port.

memory cards must be connected to the USB

Pub. 42004-442D

Page 11 of 17