Automatic Technology Australia GDO-8 v1 EasyRoller II Handleiding voor installatie-instructies - Pagina 16
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20 pagina's.
Pagina afdrukkenDOOR OPENER STATE
OPEN
CLOSE
OPENING
CLOSING
DOOR TRAVEL STOPPED
DOOR OBSTRUCTED WHEN OPENING
DOOR OBSTRUCTED WHEN CLOSING
OPENER OVERLOADED
MAINS POWER INTERRUPTED
OPERATE
Door Code
Force Margin Set + Plus (+)
Force Margin Set + Minus (-)
Force Margin Set (then) Set
Close for 6 Secs
Set (then power on) & hold until all LEDs are off
Door Code (then power on) & hold until all LEDs are off
Set for 2 sec.
Purchased From ___________________________________ Phone ______________________
Installed By _______________________________________ Date _______________________
Serial No. ________________________________________
PARAMETERS
DOOR STATUS INDICATORS
OPEN LED
FLASHING
FLASHING
FLASHING
ALTERNATING
BUTTONS
CLOSE LED
GREEN
RED
ON
ON
FLASHING
FLASHING
FLASHING
ALTERNATING
FLASHES
FLASHES
RAPID
FLASHES
Opens/Stops/Closes the door
Codes a transmitter button for OPERATE function
Increases the obstruction force margin setting
Decreases the obstruction force margin setting
Reloads the factory set default obstruction force margin setting
Clears the door limits set positions. Limits then need to be reset.
Deletes control parameters excluding transmitter storage memory.
Deletes all transmitter stored in memory.
Re-initialises the Opener to re-calculate force margins
16
DOOR STATUS
BEEPER
LED YELLOW
BEEPS WHILE
DOOR IS MOVING
FUNCTION