GReddy TYPE-RS BRS-610 GDB Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GReddy TYPE-RS BRS-610 GDB. GReddy TYPE-RS BRS-610 GDB 8 pagina's. Rs-type adapter kit

Pagina afdrukken

GReddy TYPE-RS BRS-610 GDB Gebruiksaanwijzing

Install the provided return pipe to the cut

(3)

air bypass hose as shown.

Route the return pipe under the left

※

intercooler bracket as shown.

Remove the discharge funnel off from the

(4)

blow off valve and install the valve on to the

intercooler using the provided gasket and

valve.

The attachment can be easily turned off.

※

Make sure not to damage the o ring.

Reinstall the intercooler and connect the

(5)

turbo out let hose and throttle body hose.

Connect the return pipe to the blow off

(6)

valve with provided 34 silicone hose.

Reconnect the vacuum hose to the top of

(7)

the blow off valve and place the emblem on

the top cover.

Starting the engine

(1) Inspect the installation. Reconnect the negative terminal of the battery and start the engine.

(2) Check and make sure that there no air leeks, clearance problems or irregular sound.

(3) Lightly rev up the engine couple times to check if the blow off valve is operating.

Adjustment after installation

If irregular idle or engine stall occurs, loosen the M6 lock nut and turn the adjustment screw to

HARD

HARD until the problem is eliminated.

After the adjustment, tighten the lock nut to secure the setting.

The adjustment is preset to the softest position form factory. Do not turn it further out that

※

this position.

Make sure to loosen the lock nut before making adjustment. Turning the adjusting screw

※

without loosening the lock nut will strip out the top housing.

When the adjustment screw is turned in, the stock of the valve decreases. Screwing it in too

※

far will affect the proper operation of the valve.

Intercooler bracket

Return hose

7－

－