Celestron 11091 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Celestron 11091. Celestron 11091 20 pagina's. Telescope and equatorial mount

Congratulations on your purchase and welcome to the Celestron world of astronomy. If you're a newcomer

to the hobby of astronomy, some of the terms and telescope components described in this instruction

manual may be new to you. This manual is designed to instruct you in the proper use of your Celestron G-3

and G-5 telescopes. To assist you in assembling and operating your telescope, take time to review this

manual and the parts diagram listed in Figures 1 & 2.

WARNING—NEVER LOOK AT THE SUN WITH YOUR TELESCOPE OR ITS FINDERSCOPE.

PERMANENT AND IRREVERSIBLE EYE DAMAGE MAY RESULT AS WELL AS DAMAGE

TO YOUR TELESCOPE.

HOWEVER, YOU MAY ENJOY LOOKING AT THE SUN IF YOU HAVE A SAFE METHOD OF

DOING SO—A SOLAR FILTER. IF USING A SOLAR FILTER, MAKE SURE THE

FINDERSCOPE IS COVERED.

The telescope and all items are packed in one box. Included are:

Telescope Optical Tube

German Equatorial Mount

Adjustable Aluminum Tripod

¼" x 20 photo mounting platform (used for G-3 model)

6x30 Finderscope and Bracket (for G-5 models); 8x20 Erect Image Finderscope ( for G-3 models)

Counterweight Shaft and Counterweights (2.2 Kg )

Tripod Accessory Tray

Declination Slow Motion Knob

Right Ascension Slow Motion Knob

25mm SMA –1 ¼" Eyepiece

90º Star Diagonal – 1 ¼" (for G-5 Models); 90º Hybrid Diagonal – 1 ¼" ( for G-3 models)

"The Sky" level I CD-ROM

RA Motor Drive (for models #11091 & #11051)

Setting Up the Tripod:

The tripod legs come pre-assembled with the center leg support bracket attached to the inside of each tripod

leg. Each leg must then be attached to the tripod head of the equatorial mount.

Remove the tripod legs from their shipping box and place them horizontally on a flat surface.

Lie the metal tripod head on its side. Attach the three tripod legs one by one by sliding the bolt at the

top of each tripod leg into the slotted cut-outs located on the bottom of the tripod head. Tighten the

wing nuts on the end of the bolts to secure each tripod leg.

Stand the tripod with the tripod head attached on its feet and separate the tripod legs until the center

support bracket is fully extended.

Attaching the Accessory Tray

Next, attach the accessory tray to the tripod. Locate the accessory tray and the three wingnut screws to

attach the tray.

INTRODUCTION

TELESCOPE ASSEMBLY